Smartenit Motion Sensor

Smart Home
Updated 07-07-2017 06:00:58 AM 39338
This Article Applies to: 

How to add a Smartenit motion sensor to the Deco network?

  • Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Sensors -> Motion Detector (Smartenit) -> NEW DEVICE.
  • Tap NEXT, the app will say Searching…
  • Press the Auxiliary Button once every 10 seconds to keep the ZBMS3-1 scanning until joined to the network.
  • The Status LED will flash green once when the device finds a viable network to join and then blink 5 times when fully joined.
  • When the device is discovered, tap NEXT and choose a location for it. Then tap DONE, and the device will list on the app.

 

How to reset a Smartenit motion sensor?

Press and hold the Auxiliary button (B) until the Status LED (A) blinks green rapidly, indicating it’s ready to join a network.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

 

Troubleshooting

Fail to add the sensor / the sensor is offline/unreachable

  • Move the sensor closer to the Deco router;
  • Avoid physical obstructions and radio interference in the surrounding area;
  • Reset the sensor and re-add it to the Deco network.

Полезен ли беше този ЧЗВ?

Вашите отзиви помагат за подобряване на този сайт.

Препоръчани продукти

From United States?

Get products, events and services for your region.