Securifi Door/Window Sensor
This Article Applies to:
For SZ-DWS02
How to add the sensor to the Deco network?
- Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Sensors -> Door/Window Sensor (Securifi) -> NEW DEVICE.
- Remove the sensor cover, then press the Join/Reset button for less than 1 second.
- Tap NEXT when the LED is blinking, the app will say Searching…
- Wait up to 60 seconds until the device is discovered. If not, tap SCAN AGAIN.
- When the device is discovered, tap NEXT and choose a location for it. Then tap DONE, and the device will list on the app.
- Put the cover back on the sensor.
How to reset the sensor?
- Remove the back of the sensor.
- Press and hold the “Join/Reset” button (C) for 15 seconds until the green LED (D) lights up briefly.
Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.
For SZ-DWS04_SF/SZ-DWS04
How to add the sensor to the Deco network?
- Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Sensors -> Door/Window Sensor (Securifi) -> NEW DEVICE.
- Remove the sensor cover.
- Press the Join/Leave button for less than 1 second.
- Depress the tamper switch for 3 seconds before inserting the battery. Insert the included battery. Release the tamper switch while the LED is illuminated.
- Tap NEXT when the LED is blinking, the app will say Searching…
- Wait up to 60 seconds until the device is discovered. If not, tap SCAN AGAIN.
- When the device is discovered, tap NEXT and choose a location for it. Then tap DONE, and the device will list on the app.
- Reattach the cover of the sensor and make sure it snaps in place properly.
How to reset the sensor?
- Open the case backing and remove the battery (A) from the sensor.
- Keep the tamper switch (B) pressed while re-inserting the battery (A) and release it while the LED is illuminated.
Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.
Troubleshooting
Fail to add the sensor / the sensor is offline/unreachable
- Move the sensor closer to the Deco router;
- Avoid physical obstructions and radio interference in the surrounding area;
Reset the sensor and re-add it to the Deco network.
Полезен ли беше този ЧЗВ?
Вашите отзиви помагат за подобряване на този сайт.