How to reset VIGI NVR to factory defaults

VIGI NVR

Updated 12-27-2023 10:51:15 AM

59384

This Article Applies to:

If you want to reset VIGI NVR to the factory default settings, please follow the methods below:

Method 1: By using the management page of VIGI NVR

Step 1. Click Settings on the Main Menu.

Step 2. Go to Settings -> System -> System Configuration -> Settings Management, and click Reset.

Step 3. Click Yes. The NVR will restore to its factory default settings.

Note: Please wait without any operations until the NVR is reset successfully. It may take a few minutes.

Method 2: Hard reset/ By pressing the RESET button

Remove the cover of the NVR, then press and hold the Reset button inside the NVR for over 3 seconds. The NVR will restore to the factory settings.

Note: Please wait without any operations until the NVR is reset successfully. It may take a few minutes.

Is this faq useful?

Your feedback helps improve this site.