Téléchargement pour OC300 V1

IMPORTANT: les disponibilités des modèles et des versions matérielles varient selon les régions. Merci de vous référer au site TP-Link du pays qui vous concerne.
Manual
Contrôleur Hardware Omada (<500 appareils)
OC300

Setup Video

  • How to Set Up the Whole Network of Gateway, Switches, and EAPs Using Omada SDN Controller

    This video will demonstration how to do a full configuration with TP-Link Omada products including gateway, switches and EAPs. As an example, we are going to build the wired and wireless networks from scratch at our TP-Link Office. The setup consists of 7 steps: Step 1. Log in to the Controller Step 2. Adopt Devices Step 3. View Dashboard and Menus Step 4. Set up WAN Step 5. Set up LAN and VLANs Step 6. Set up Wi-Fi Step 7. Set up ACL

    Plus Fold

  • How to configure Omada Hardware Controller via Omada App

    This videos shows how you to set up the Omada Hardware Controller (OC200 is used as an example) via Omada app locally and remotely.

    Plus Fold

  • How to configure Omada Hardware Controller via a Web Browser

    This videos shows how you to set up the Omada Hardware Controller (OC200 is used as an example) via a web browser locally and remotely.

    Plus Fold

  • How to Choose an Omada SDN Controller

    This video will show you how to choose an Omada SDN Controller and its management interface.

    Plus Fold

  • How to setup the Omada Hardware Controller (OC200/OC300) via web browser

    This video will demonstrate how to set up OC200/OC300 via web browser. The setup consists of four steps: • Connect the controller to your local network. • Log in with your TP-Link ID. • Add the controller to your TP-Link ID. • Set up the controller THIS VIDEO APPLIES TO: • All TP-Link EAP models (except EAP120 and EAP220) • Omada Hardware Controller (OC200/OC300) • Mass EAPs (usually more than three)

    Plus Fold

  • How to setup the Omada Hardware Controller (OC200/OC300) via your mobile phone

    This video will demonstrate how to set up OC200/OC300 via your mobile phone. The setup consists of four steps: • Connect the controller to your local network. • Log in with your TP-Link ID. • Add the controller to your TP-Link ID. • Set up the controller THIS VIDEO APPLIES TO: • All TP-Link EAP models (except EAP120 and EAP220) • Omada Hardware Controller (OC200/OC300) • Mass EAPs (usually more than three)

    Plus Fold

Filtre: Tout Guide de ConfigurationApplication utilisateur requiseAvant d'acheterDépannageDurant l'installationAvis de SécuritéAssistance avancéeExplications sur le Q&A Déclaration Officielle

FAQs