Λήψεις για T1600G-52TS V4

Επιλέξτε έκδοση υλικού:

>How to find the hardware version on a TP-Link device

ΣΗΜΑΝΤΙΚΟ:Η διαθεσιμότητα έκδοσης μοντέλου και υλικού διαφέρει ανάλογα με την περιοχή. Ανατρέξτε στον τοπικό ιστότοπό σας TP-Link για να προσδιορίσετε τη διαθεσιμότητα των προϊόντων.

Επισκόπηση προϊόντος

T1600G-52TS(UN)_V4_Datasheet

Εγχειρίδια

Αρχεία MIBs

T1600G-52TS(UN)_v4_MIB_20190321

Λήψεις

Ημερομηνία Έκδοσης: 2019-09-25

Γλώσσα: Αγγλικά

Μέγεθος αρχείου: 200.17 KB

Λειτουργικό Σύστημα : Win2000/XP/2003/Vista/7/8/8.1/10/Mac/Linux

T1600G-52TS(UN)_V4_MIB_20180716

Λήψεις

Ημερομηνία Έκδοσης: 2019-05-13

Γλώσσα: Αγγλικά

Μέγεθος αρχείου: 206.12 KB

Λειτουργικό Σύστημα : Win2000/XP/2003/Vista/7/8/8.1/10/Mac/Linux

802.1X Client

TP-LINK_802.1X_Client_Software

Λήψεις

Ημερομηνία Έκδοσης: 2017-09-05

Γλώσσα: Αγγλικά

Μέγεθος αρχείου: 5.5MB

Λειτουργικό Σύστημα : Win2000/XP/2003/Vista/7/8/8.1/10

Συχνές ερωτήσεις

How to configure LACP on our Smart/ Managed Switch 10-29-2024236491
How to Block Unknown Devices to Access the Switch by Using IP Source Guard 08-09-202476215
Why the firmware version does not change after upgrading in T Series switches? 08-09-202462767
How to configure the default gateway of the smart and managed switches using the old GUI 08-09-2024259014
The difference between the Voice VLAN feature and Auto VOIP feature 07-23-202480189
What should I do if I cannot access the web management page of my TP-Link switch? 07-23-2024349632
Do you still have any doubt about the effect of QoS on the Switch of TP-Link? 07-23-202489505
How to block an illegal client with Certain IP address from getting access to the network using TP-Link Managed Switches 07-01-202479231
How to Configure Port Isolation Function on Our Layer 2 Manage switches through Web Browser 06-29-2022128584
How to Configure Port Mirror on TP-Link Smart Switches and L2 Managed Switches 06-29-202282852
How to configure 802.1q VLAN on Smart Switches 06-29-2022148399
How to limit the port rate of the incoming traffic via ACL function 06-28-202259392
How to test the Jumbo Frame pass-through feature on TP-Link switches 06-28-2022185596
How to build up a multi-nets network via Multi-Nets NAT feature on TP-Link router with L2+/L3 switches 06-28-2022325707
How to change the IP address of the smart and managed switches using the old GUI and CLI 06-28-2022327210
How to configure MAC ACL on Smart/Managed switch 06-28-202285153
How to configure the DHCP Relay in TP-Link Switch 06-27-2022256724
How to configure Voice VLAN to optimize the transmission of voice traffic on TP-Link Smart and Managed Switches using the new GUI 06-27-2022111096
How to configure 802.1Q VLAN for LAG ports on Smart and Managed switches using the new GUI 06-27-202290277
How to achieve AAA Authentication through TACACS + server on the switch 11-22-202159859
How to configure OpenSSH 7.0(and above) to login smart and managed switches? 04-17-2018133789
The nodes that TP-Link T1600/T2600 series switch use to display the CPU and Memory utilization through SNMP 12-26-201669002
How to configure Extended IP ACL 04-28-201285577

Firmware

A firmware update can resolve issues that the previous firmware version may have and improve its current performance.

To Upgrade

IMPORTANT: To prevent upgrade failures, please read the following before proceeding with the upgrade process

Please upgrade firmware from the local TP-Link official website of the purchase location for your TP-Link device, otherwise it will be against the warranty. Please click here to change site if necessary.
Please verify the hardware version of your device for the firmware version. Wrong firmware upgrade may damage your device and void the warranty.
How to find the hardware version on a TP-Link device
Do NOT turn off the power during the upgrade process, as it may cause permanent damage to the product.
To avoid wireless disconnect issue during firmware upgrade process, it's recommended to upload firmware with wired connection unless there is no LAN/Ethernet port on your TP-Link device.
It's recommended that users stop all Internet applications on the computer, or simply disconnect Internet line from the device before the upgrade.
Use decompression software such as WinZIP or WinRAR to extract the file you download before the upgrade.

T1600G-52TS(UN)_V4_20200918.

Λήψεις

Ημερομηνία Έκδοσης: 2021-05-21

Γλώσσα: Αγγλικά

Μέγεθος αρχείου: 8.67 MB

ew Features/Enhancements:
Add the feature that supports to be managed by the Omada SDN Controller. In the controller mode, some advanced functions will be limited. You can refer to the FAQ2936 to see the functions that can be configured on the controller.

Notes:
1. For T1600G-52TS(UN) V4.0
2. Your device's configuration will not be lost after upgrading, which means you don't need to configure your device again after upgrading.
3. If you choose to manage the switch with controller mode, the settings you configured in standalone mode will lose after the switch is adopted by the controller.

T1600G-52TS(UN)-V4-20200109

Λήψεις

Ημερομηνία Έκδοσης: 2020-03-27

Γλώσσα: Αγγλικά

Μέγεθος αρχείου: 9.49 MB

New Features/Enhancements:
1. Add the feature that needs to change the password when login for the first time.
2. Add the feature that can choose not to change the IP address when resetting the switch.
3. Add "service reset-disable" for removing reset option from Bootutil.
4. Add built-in Telnet client which allows the switch can telnet other devices.
5. Allow disabling HTTP and HTTPS for access types at the same time.
6. Optimize the password character set to support more special characters.
7. Optimize the BPDU Filter feature to make ports not send out BPDU packets when BPDU Filter is enabled.
8. Optimized the CLI display of MVR configurations.
9. Support to display MVR members of inactive and active groups.
10. Support to view/clear mac-address table on port/VLAN.
11. Support to fill in file name with folder path when using SNMP or CLI to upgrade firmware or restore config file through TFTP.
Notes:
1. For T1600G-52TS(UN) V4.0
2. Your device's configuration will not be lost after upgrading, which means you don't need to configure your device again after upgrading.

3. After upgrading, it cannot downgrade to the old version firmware because of the encryption rule has changed.

T1600G-52TS(UN)_V4_20190516

Λήψεις

Ημερομηνία Έκδοσης: 2019-07-04

Γλώσσα: Αγγλικά

Μέγεθος αρχείου: 9.71 MB

Modifications and Bug Fixes:
1. Update HTTPS to support TLS1.2.
2. Fix the bug that the settings of SNMP Community/Notification/Trap will lose after rebooting the switch when turning off the global switch of SNMP function.
3.Fix the bug that the IP in circuit-ID is wrong when the VLANs which the port belong to does not set up the interface and PPPoE IP insertion is IP mode.
4. Fix the bug that NTP server will be changed when setting up only one NTP server and fail to get the time.
5. Fix the bug that cannot set up auto mode for fibre ports which in the port channel.
6. Fix the bug that access control entries will not take effect when two or more entries are added for port binding.

Notes:
For T1600G-52TS(UN) V4.0.

To Use Third Party Firmware In TP-Link Products

Some official firmware of TP-Link products can be replaced by the third party firmware such as DD-WRT. TP-Link is not obligated to provide any maintenance or support for it, and does not guarantee the performance and stability of third party firmware. Damage to the product as a result of using third party firmware will void the product's warranty.

Open Source Code For Programmers (GPL)

Please note: The products of TP-Link partly contain software code developed by third parties, including software code subject to the GNU General Public Licence (“GPL“), Version 1/Version 2/Version 3 or GNU Lesser General Public License ("LGPL"). You may use the respective software condition to following the GPL licence terms.

You can review, print and download the respective GPL licence terms here. You receive the GPL source codes of the respective software used in TP-Link products for direct download and further information, including a list of TP-Link software that contain GPL software code under GPL Code Center.

The respective programs are distributed WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the respective GNU General Public License for more details.

Κώδικας GPL

T1600G-52TS(UN)_V4_GPL

Εξομοιωτές

Έκδοση Υλικολογισμικού	Τρόπος Λειτουργίας	Γλώσσα
180716	-	Αγγλικά	Δες
180716	-	Αγγλικά	Δες

Σημείωση:

1. Ο εξομοιωτής είναι ένα εικονικό GUI ιστού όπου μπορείτε να δοκιμάσετε τον πίνακα διαχείρισης προϊόντων TP-Link.

2. Οι εξομοιωτές που αναφέρονται ενδέχεται να μην έχουν το πιο πρόσφατο υλικολογισμικό.

3. Τα χαρακτηριστικά που εμφανίζονται είναι για αναφορά και η διαθεσιμότητά τους μπορεί να εξαρτάται από τους τοπικούς κανονισμούς. Για περισσότερες πληροφορίες, ανατρέξτε στο φύλλο δεδομένων ή στη σελίδα προϊόντος.

Από United States?

Λάβετε προϊόντα, εκδηλώσεις και υπηρεσίες για την περιοχή σας.

ΠΑΜΕ Άλλη Επιλογή

Λήψεις για T1600G-52TS V4

Αρχεία MIBs

802.1X Client

Συχνές ερωτήσεις

Firmware

To Upgrade

To Use Third Party Firmware In TP-Link Products

Open Source Code For Programmers (GPL)

Κώδικας GPL

Εξομοιωτές

Q&A

Οδηγός διαμόρφωσης