How to configure guest network on Omada Controller
8902 Contents
This article describes how to configure guest network on the Omada controller.
- Omada Controller (Software Controller / Hardware Controller / CBC, v5.9 and above)
- Omada AP
The guest network allows you to set up a network that is independent of the main network. You can configure a separate SSID and password for the guest network, allowing guests to access the internet while being isolated from the main network. Clients connected to the guest network can access the internet but cannot access or download the internal network resources, thereby safeguarding the privacy and network security of the main network
Step 1. Go to Setting > Wireless Network > WLAN and click Create New Wireless Network to load the following page.
Step2. Custom the Network Name(SSID), select a Security mode (here WPA-Personal is used as an example), enter the Security Key, check the box to enable Guest Network, and click Apply to save the settings.
Once configured, you can use two clients to verify that the function works.
Step 1. Connect two clients to the SSID, for example, a desktop computer (IP: 192.168.0.102) and a mobile phone (192.168.0.101).
Step 2. On the desktop computer, ping the mobile phone’s IP. The ping fails, but both the computer and the phone can access the internet, indicating that the function has been enabled and is working properly.
Guests can access the internet through the guest network.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.
Is this faq useful?
Your feedback helps improve this site.
