How to configure Jumbo Frame on Omada Controller
2963 Contents
Objective
This article describes how to configure the jumbo frame of switches through the Omada Controller.
Requirements
- Omada Smart/ L2+/L3 switches
- Omada Controller (Software Controller / Hardware Controller / Cloud-Based Controller, V5.9 and above)
Introduction
In the traditional Ethernet standard, a frame's maximum length is limited to 1518 bytes. However, as network speed increases, this limitation may lead to insufficient utilization of network bandwidth and reduced processing efficiency, especially in a Gigabit Ethernet environment. In order to solve this problem, Jumbo Frame technology came into being.
Configuration
Step 1. Go to Devices > Device List and click the name of a desired switch to enter its Properties window.
Step 2. Set an appropriate Jumbo Frame value in the Config section, as shown below.
Note: To fully utilize the advantages of Jumbo Frame, make sure all devices in the network support this feature.
Conclusion
You have successfully configured the Jumbo Frame on the Controller.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.
Is this faq useful?
Your feedback helps improve this site.
3.2_normal_1594974261923z.png)
1.0_Omada_Enterprise_L3_Switch-1000px_normal_20231110111227a.png)
TP-Link Community
Still need help? Search for answers, ask questions, and get help from TP-Link experts and other users around the world.