How to Set TD-W8960N/TD-W8950ND QoS for RTSP
43413 Before you begin, please note:
Suppose the Internet parameters from your ISP are as following and you have connected to the Internet successfully.
Connection type: PPPoE
VPI/VCI: 8/35
User name and password
QoS for RTSP
Suppose the topology is as following, please follow the steps to make RTSP data have the highest priority for the whole network.
Configuration for QoS:
Step 1 Open web browser and enter 192.168.1.1 in your address bar, then press "Enter".
Step 2 Enter the username and password of your modem. By default it will be Username: "admin" and Password: "admin" or if you have changed this, please enter the new username and password.
Step 3 Go to Quality of Service, please check Enable QoS
Step 4 Go to Queue Config, then click add button to add a queue. Set following parameters as below:
After save, we will get the rule as below:
Step 5 Go to QoS Classification, then click add button to add two Classifications.
Set following parameters as below:
TCP for RTSP is almost the same:
Note: If QoS is applied in some single computer, please set the Source IP Address with Subnet Mask or Source MAC address in the rule.
After save, we will get the rule as following:
Now you can test RTSP QoS with the settings.
Note: For further information of the options, please refer User Guide coming with the product.
Bu SSS faydalı mı?
Your feedback helps improve this site.
