TP-Link Smart Bulb (Wi-Fi)

Para LB100/LB110/LB120/LB130

¿Cómo agregar una bombilla inteligente TP-Link a la red Deco?

• Configure la bombilla a través de la aplicación Kasa y conéctela a la red Wi-Fi de Deco;
• Launch Deco app, tap the Add icon at the upper right corner, then choose Smart Devices -> Lights -> Smart Bulb (TP-Link).
• Tap NEXT, the app will say Searching…
• Wait up to 30 seconds until the bulb is discovered. If not, please tap TRY AGAIN.
• When the bulb is discovered, tap NEXT and choose a location for the bulb. Then tap DONE, and the bulb will list on the app.

How to reset a TP-Link smart bulb?

• To reset the bulb without losing the configuration settings:

1. Turn the light switch controlling the bulb to the OFF position.
2. Flip the light switch on and off 3 times.

• To reset the bulb to factory defaults:

1. Turn the light switch controlling the bulb to the OFF position.
2. Flip the light switch on and off 5 times.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

Troubleshooting

Fail to search the bulb / the bulb becomes unreachable/offline

• Check the light switch of the bulb and make sure it’s always switched to the ON position;
• Make sure Remote Control is enabled on Kasa app.
• Move the bulb closer to the Deco router.
• Avoid physical obstructions and radio interference in the surrounding area.
• Reset the bulb and reconnect it to the Deco network.