Gunilamp Smart Luminaire

How to add a Gunilamp Smart Luminaire to the Deco network?

• Launch the Deco app, tap the Add icon at the upper right corner, choose Smart Devices -> Lights -> Smart Luminaire (Gunilamp) -> NEW DEVICE.
• Power on the bulb and wait until the light starts flashing in blue.
• Tap NEXT, the app will say Searching…
• Wait up to 30 seconds until the bulb is discovered. If not, tap SCAN AGAIN.
• When the bulb is discovered, tap NEXT and choose a location for the bulb. Then tap DONE, and the bulb will list on the app.

How to reset a Gunilamp Smart Luminaire?

Switch on/off button five times until the light starts flashing in blue.

Note: If the device fails to reset, please refer to the setup guide of the device’s manufacturer for more information.

Troubleshooting

Fail to add the bulb / the bulb is offline/unreachable

• Make sure the bulb is already factory reset before you add.
• Make sure the bulb is powered on.
• Move the bulb closer to the Deco unit.
• Unplug and re-plug the bulb, then try again.
• Avoid physical obstructions and radio interference in the surrounding area.
• Reset the bulb and re-add it to the Deco network.

If the problem persists, please contact our technical support team.