What should I do when speed test results do not meet expectations?
5543 Contents
This article will introduce the troubleshooting methods when speed test results do not meet expectations due to incorrect device or test configuration.
- Omada Gateway
- Omada Controller (software Controller / hardware Controller / Cloud-Based Controller v5.9 and above)
Speed test results not meeting expectations are usually caused by incorrect configuration of functions such as Bandwidth Control, QoS, Flow Control, and Rate Limit. Please check as follows:
Step 1. Check whether the links from ISP > Modem > Gateway > Switch > PC are all at the highest speed. You can go to Site > Devices and click on a device to check the link speed of each port.
Step 2. Check whether the speed is the same for each link segment. When there is an unequal speed in your link, the speed measured from the high bandwidth to the low bandwidth direction may be lower. Try enabling flow control for the entire link at Site > Devices > Ports > Edit, then test the speed again.
Note: When there is a wireless link, ensure its negotiation rate is the highest, and select a channel with less interference. The wireless speed test result is closely related to the environment. Factors such as wireless signal strength, signal interference, and device performance will affect the test results.
Step 3. Check the bandwidth-related configurations on the devices: Bandwidth Control and QoS on Gateways, Rate Limit and QoS on Switches, and Rate Limit for SSID and Clients on EAPs. Try disabling or deleting the relevant configurations, then test the speed again.
Step 4. Check whether the CPU utilization is less than 80%. If it is higher than 80%, check whether there is a loop in the network.
Step 5. Check the speed test.
- When using SpeedTest, try changing the test node, and choose the closest nodes to test. The algorithm differences between different test nodes may lead to significant differences in the test results.
- When using iperf3 for speed testing, use the -P [nums] parameter to specify multiple streams, which will make the test results more stable.
- During the test, turn off other applications that may occupy network bandwidth to get more accurate test results.
Step 6. Confirm the upstream and downstream bandwidth provided by the ISP. When using an internet node (such as SpeedTest) for speed testing, the speed limit is the bandwidth provided by the ISP.
Step 7. Ensure your firmware is up to date. To check the latest firmware version, go to our official website: https://www.tp-link.com/en/business-networking/omada-router-wired-router/
Step 8. Restart the Modem, Gateway, Switch, and EAP if necessary.
Try to troubleshoot the problem according to the above steps. If the problem still exists, collect the information of network topology, Controller configurations, and ISP bandwidth, and contact our technical support for assistance.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.
¿Es útil esta pregunta frecuente?
Sus comentarios nos ayudan a mejorar este sitio.